Before you begin, please make sure you have the following:

• Access to the Hydra charger’s configuration settings (typically accessed via the charger's interactive touchscreen)
• Administrative credentials (The charger's touchscreen is password protected. If you don't know the password, please contact Hydra support)
• Internet connection for the charger
• Charger must support OCPP 1.6 JSON

1. On the charger's touchscreen, navigate to 'Settings' followed by the 'URL' tab
2. Enter the Fuuse URL: ws://smes.hw.fuuse.io
3. Press 'OK'
4. You may need to wait a few minutes for the charger to appear in Fuuse
5. If the charger does not appear in Fuuse, try and reboot the charger or turn off for 10 seconds and turn on again.